FRP cooling tower work process to work process circular cooling tower as an example: through the pump room independent hot water to a certain pressure through pipes, cross throat, larynx song, the center will loop hydraulic hose to the cooling tower water play within the system, pipe through the hole on the broadcast spraying water evenly on top of the filling; air dry low Han values ??under the influence of wind turbines from the bottom of the net into the tower to form when hot water flows through the filler surface film and the air subjected to heat exchange, the hot air of high humidity Han values ??extracted from the top, the cooling water droplets into the bottom of the basin, through the outlet pipe flows into the host. In general, the air entering the tower, dry bulb temperature low humidity air cooling tower, there is obviously when the fan is running, the effect of the concentration of water column hydrostatic pressure difference and the kinetic energy of the molecules of the pressure difference between water and air under constant water molecules evaporate into the air, become water vapor molecules, the remainder of the average kinetic energy of water molecules will be reduced, so that the circulating water temperature drop. As can be seen from the above analysis, evaporative cooling and air temperature (dry bulb temperature usually say) lower or higher than the water temperature has nothing to do, as long as water molecules can continue to evaporate into the air FRP cooling towers, water temperature is reduced. Automatic rotary atomizer cooling tower circulating cooling water through the cold, dry air, evaporation heat transfer and circulating cooling water away latent heat of vaporization to achieve the purpose of lowering the water temperature. A certain pressure of the circulating cooling water through the inlet into the cooling tower cooling tower cost and, in the role of the injector swirl atomizer, is atomized into mist having a diameter of 0.1mm to the top of the ejection direction, ejection reverse thrust generated by drive Automatic rotating means for rotating, resulting atomized water to fill the entire tower. Axial fans mounted on a rotating tower, the cold surroundings, dry air is forced through the windshield suction inlet cooling tower and circulating cooling water mass transfer, heat transfer. Atomizer spray atomization flow velocity out quickly, and has entrainment entrainment, so have some negative nebulizer around the cooling tower manufacturers, and increased the amount of ventilation cooling tower from the surrounding environment and into the air flow rate, while driving the bottom upward air flow, resulting in cold, dry air is mixed with water mist, contact fuller (gas-water ratio of up to 1.2), atomized water particles have been further refined, can be reduced to a diameter of 0.01mm, gas, the flow of water mist spray thoroughly mixed to be installed on top of the tower or water, the water is trapped and curtain-like return to heat the cooling tower, air and water tower Ganzi Tibetan discharge via cooling towers or water _ _ closed cooling tower Rainbird environment (certified merchants) by Wu County Rainbird Environmental Engineering Limited. Wu County Rainbird Environmental Engineering Co., Ltd. (www.dzrbtf.com) (www.dzrbtf.com) is specialized in the "glass blower, induced fan, intelligent induction fan, cooling tower" of the enterprise, the company of "honesty, hard service "concept, to provide you with the highest quality products and services. Welcome to inquire! Contact: Zhengjing.